driven pulley造句
例句與造句
- Vibration or eccentric spindle driving pulleys
釘子傳動齒輪振動或偏心。 - Specification for generating racks for synchronous belt drive pulleys
皮帶同步傳動輪齒條規范 - Vertical bucket elevator . driving pulley . parameters dimensions
垂直斗式提升機.傳動滾筒參數尺寸 - Poly v drive pulley
形驅動滑輪 - Poly v drive pulley
形驅動滑輪 - It's difficult to find driven pulley in a sentence. 用driven pulley造句挺難的
- By placing the clutch on the driven pulley , the pulley can remain spinning even when the car is stopped
將離合器安裝在從動輪上，即使停車時滑輪也能夠連續旋轉。 - The power output from the engine goes through : front / back switch mechanism - > driving pulley - > metal belt - > driven pulley - > clutch
輸出功率從發動機經下列路線輸出：前后轉換機械開關- >驅動滑輪- >金屬帶- >從動輪- >離合器。 - Owing to the diameters of big and small pulleys are different , while the driving pulley rotates the differential mechanism will not stay at its original place and will make linear movement along the direction of centerline
當主動輪轉動時，由于大小差動帶輪的直徑不同，差動機構就不會停留在原處，而會沿中心線方向上作直線移動。 - Abstract : in this study distributions of block compression force on the driving and driven pulleys were measured using a ting load - cell inserted between two blocks and a telementer system , under several constant speed ratios
文摘:本研究采用超小型測力儀插入兩推塊和遙測裝置之間在幾種固定速比下測量主動和從動帶輪上推塊壓縮力分布。 - Ratio control of cvt is the key for engine running according to ideal curve , and controlling thrust of driving and driven pulley reasonably can improve efficiency and extend life - span of metal belt , and it is coupling relation between control of ratio and thrust
無級變速傳動系統的速比控制是實現發動機按理想工作線運行的關鍵，合理控制主、從動帶輪的夾緊力能提高傳動效率和金屬帶的壽命，而夾緊力和速比控制存在耦合效應。 - Based on the analysis of motion characteristic of metal pushing v - belt type continuously variable transmission and transmission mechanism of metal belt , the relationship between the thrust of driving and the driven pulley are ascertained under no load and load , and the control model of pressure of driving and driven pulley oil cylinder are established in different ratio and transmitted torque
本論文在分析金屬帶式無級變速傳動系統的運動特性及v型金屬帶的傳動機理的基礎上，確立了空載條件下和載荷條件下主、從動帶輪的夾緊力及其關系，建立了在不同速比、不同輸入轉矩下主、從動帶輪油缸壓力控制模型。 - 3 ) based on experimental analysis , the relation among the speed ratio changing rate , oil pressure of driving and driven pulley cylinders , driving pulley input speed and torque , metal belt speed ratio has been studied . model for getting the ratio changing rate is put forward , and practical equation giving the ratio changing rate is obtained by experiments
3 ）通過實驗分析，研究了主、從動輪油缸壓力、主動輪轉速、輸入轉矩和帶式無級變速傳動速比與速比變化率的關系，建立了獲取cvt速比變化率的模型，導出了符合實際規律的實用計算公式。